EZCAD Software show Can Not Find the LMC1 Drive?
When open ezcad software,it show can’t find the LMC1 Driver.
Here are the solution to check this problem.
1) USB line problem, After the device is powered off, re-plug the cable and restart it; Or just change the USB line.
2) Software is broken. Delete all EzCad software in computer, copy new one and install the drive.
3) Control board is broken: After opening the hardware device manager, the hardware driver of the board cannot be found, there is no hardware prompt after re-plugging, or the prompt does not recognize the hardware. In this case, consider replacing the new board.
86 13854105019
86 13854105019
Skype
ChinaLindahao
sales@sismarlaser.com
#EZCAD #LaserMarkingMachine #FiberLaserMarkingMachine #UVLaserMarkingMachine #GreenLaserMarkingMachine #Co2LaserMarkingMachine #LaserMarking #LaserMarker #Laser #LaserEngraver #LaserCuttingMachine #LaserCutter