EZCAD Work in the Demo version

When open EZCAD software,it appears “can’t find dongle,software will work at demo state”.

It means the software can not connect the control card, the reasons might be:

1)You did not power on the machine, the control card is not in ready mode
Solution: Just power on the machine.

2)USB connection between the control card and software
Solution: Just check your USB connection.

3)The Control Card got some problems
Solution: 1. Replace a new card; 2. Reboot your machine before you run the software.

4)The operator did not install the Control Card Driver or Dog Driver properly.
Solution: Check which driver you did not install, then just install it.
Solution: Uninstall the software and reinstall it after you connect the machine and computer. Before reinstalling the software, we advise you to shut down the anti-virus software in advance.